This includes launching programming, recovering results, managing images resident on a Cyclone, adding unique programming data for each target, and more. The goal is to allow full control of one or more Cyclones from the PC, either from within a GUI, a custom application, or from the command-line. In addition to manual launch via the start button, stand-alone programming can be automatically controlled from a PC using the included Cyclone Control Suite. Stand Alone Programming may also be fully automated from a PC. Using the million press rated start button (one touch programming).Stand-alone programming of an image can be manually launched in several ways: The currently selected image can be changed on the touch screen.Īutomatic serialization of the target processors, as specified by the image, is fully supported without a PC. The difference between success and failure is clearly shown to the operator. Using the start button is an extremely simple and fast way to program targets on the production line as well as perform firmware upgrades in the field. The result of programming can be seen on the Success/Error LEDs as well as the touchscreen (which shows far more detail). Once a programming image is resident in the Cyclone, programming can be as simple as pressing the start button. In this case, the images for programming are downloaded into the non-volatile memory of the Cyclone in advance of programming. The Cyclone can be used to program target processors in stand-alone mode without a PC. (Exercise Control Over Remote Operations) RSA/AES Encryption (Unique ImageKeys Safeguard Valuable IP) ProCryption Security (can be added to Cyclone LC)**.Programming can incorporate sophisticated serializationĮncrypted internal memory, 16MB, 8 imagesġ0-pin port can launch programming, get status/resultsĪdvanced Features - exclusive to CYCLONE FX **ġ+ Gigabyte of encrypted internal memory stores 200+ programming images PC based SDK, Console, and GUI Control, Gang Programming, Dynamic Data ProgrammingĮasy to use touch screen interface with remote accessĪbility to provide and switch power to a target Program targets with a PC or without a PC Provides additional control, features, and visibility into remote programming PECloud: A Cloud-Based, Production Programming Management Platform NEW!.The shipping cost to some countries/areas is high and unfortunately we may have to add-on a shipping cost. We try to provide free shipping worldwide. If you want us to mark the package as a gift or sample, please contact us. If you want to know the item's declared value or if you want the declared a real value, please contact us. We will declare the value as low as we can to avoid taxes. (SOME PACKAGES TOO BIG, PROBABLY DECLARED A LITTLE MORE VALUE), and for most countries you should not have to pay import duty, but for some countries you may need to pay import duty. USB: Use to upgrade the remote, can not be used as a charger port.ALL: Long press to turn on all lights that are ticked short press to turn on/off remote controller.Only light is ticked, the functional button works. Long press can turn on/off light Short presss control tick or not. Solid means ticked, otherwise not) Used to pair the light, refer to the pairing method. 001-008: (Corresponds to the small square in the upper right of the LCD screen.SPEED-: Lower down the different scene speed.Press button"HSI/KELVIN" to locate channel ID and then rotate this button to change different IDs. MENU: Remote controller standby setting (10-60 seconds).Four buttons after "SHIFT" are used to change different parameters accordingly. SHIFT: Switch to different functions(RGB,DIMMER,CCT).HSI/KELVIN: Rotate the knob to change different color press to change different functions on the LCD screen.Click 4 times of the number button, if light turn off automatically, it indicates the light and remote has been paired successfully.
0 Comments
Leave a Reply. |